Personal View site logo
Best gear deals, direct from factories - CatchIt deals and Special deals. Also check Cameras, lenses, software, gear deals.
If you want to support this project, select one of the options below.
It is going to reversing and project support costs (hosting, etc).
I am spending good amount of time on it and your support allows to improve and expand this site.
contribution size
Exposure discrepancy between video modes and 40 fps burst mode
  • thepalaliasthepalalias
    Using the original firmware, I'm noticing (sometimes very severe) exposure differences between video modes and the 40 fps electronic shutter SH stills burst mode.

    The images below were all shot with the same lens, aperture and (according to the EXIF data) exposure time, with the Driftwood Quantum V5 Beta loaded.

    - SH model upscaled to 1920x1080
    - 24H
    - 40 fps burst mode

    What's happening with the burst mode and how do I fix it (if it can be fixed)?
  • 6 Replies sorted by
  • PtchawPtchaw
    Does the difference in exposure occur in single-frame mode?
  • DazzaDazza
    that's interesting, it does it on my camera too though not quite as much exposure difference. film modes at 1/50 are equivalent to 1/60 in Burst highspeed mode, singleframe model has the same exposure as film
  • JackBayerJackBayer
    1/60 is the slowest shutter setting allowed for the burst mode. So it can´t match the 1/50th of your film settings. Maybe it´s just that?
  • DazzaDazza
    no I don't think that is it I just tried at 1/100 at both modes and the high burst still still brighter. I can go as low as 1/40 for high burst
  • JackBayerJackBayer
    Ok, I don´t have my manual here. If it´s 40th or 60th, neither explains your problem.
  • mozesmozes
    Just tried at shutter 1/40 and 1/100 (dident get lower then 1/40)
    with iso 3200 to 12500
    No problems, all works just fine.
    I have firmware 1.1...........
Add a Comment