Mutiny has introduced the Mutiny 12G Isolator to protect video equipment with 12G SDI ports from failure. Cameras, recorders, and monitors with 12G SDI inputs and outputs are notoriously susceptible to damage due to electrostatic discharge and power surges. To help prevent this damage, Mutiny has partnered with Freak Show to create a lightweight insulator with two stages of protection. Don’t let your expensive equipment get fried! Let’s see what this new insulator from Munity is all about. The issue with 12G SDI port failures is discussed a lot on camera forums across the internet. This failure can occur when SDI cables are attached while powering equipment on/off, using cables that lack proper shielding or cables that are longer than 30 feet. RED SDI safety protocol video, source: RED Following the release of the Komodo, RED posted an SDI port safety protocol video to address best practices to protect your equipment. However, the damage to 12G SDI ports isn’t exclusive to RED – this phenomenon can occur with any video equipment with a 12G SDI port. Best practice recommends keeping all SDI cables disconnected from the camera and accessories until they are fully powered on. Additionally, it is advised to detach the SDI cables before powering down the equipment. Len 12G Galvanic Isolator | FreakshowHD Reclocking DA | Image credit: Mutiny Several products already on the market are attempting to solve this issue: SDI isolators and SDI Reclocking distribution amplifiers. SDI isolators offer some protection from electrostatic discharge and power...
Published By: CineD - Monday, 3 July, 2023