Very good stabilization
There is only one thermal pad and none at all on the main processor, because Canon is not worried about it getting warm.
Because Canon is not worried about it getting warm.
It can be plenty of reasons, like multiple cuts and lot of bad new young engineers in the teams.
Canon EOS R6 firmware 1.1.1
- A messaging is displayed when [HDMI display: Camera+External monitor] and [Overheat control: on] settings are both enabled.
- When the RF100-500mm F4.5-7.1 L IS USM is attached, an image stabilization effect of approximately six stops* is achieved through collaborative control with the in-lens image stabilization. *Focal length 500mm, Based on CIPA(Camera & Imaging Products Association) standards.
- Fixes a phenomenon in which the IS capabilities may be degraded when performing continuous shooting in cases where the RF100-500mm F4.5-7.1 L IS USM lens is attached to the EOS R6 running firmware version 1.1.0.
- When using certain RF lenses for movie shooting, the in-lens image stabilization mechanism has been improved.
- Fixes a phenomenon in which the "Slow Synchro" setting screen is not accurately displayed, when the language is set to English.
- Fixes a typo displayed on the communication setting screen, when the language is set to Korean.
- Connectivity during FTP transmission has been improved.
- Temperature detection and shooting time control in video shooting have been improved. In addition, the total shooting time when the short-time recording and power-on/off are performed repeatedly at room temperature is improved.
- The phenomenon in which the movie recording time available is not correctly displayed when the Date/Time/Zone is not set has been corrected.
Setting up
EOS R6 -- Firmware Version 1.3.0
Firmware v1.3.1
- Firmware Version 1.3.1 incorporates the following fixes and enhancements:
Adds [IPB (Light)] to 4K to enable lower bit rate shooting.- Adds [Electronic full-time MF] to the AF tab of the menu. When a lens is attached, manual focus adjustment is always possible with both One-shot AF and Servo AF.
- The transfer time (estimated value) now displays on the camera monitor during FTP transfer.
- Fixes a phenomenon, in which in rare instances, the camera cannot function normally when the drive mode is set to "High-speed continuous shooting" to shoot still images continuously.
- Fixes a phenomenon that may corrupt the image displayed in the viewfinder.
- Fixes a phenomenon in which the power may become suspended when the camera is powered via USB for an extended period of time.
- Fixes a phenomenon, in which the camera stops to operate normally when the movie cropping setting is set to [Enable] for performing movie shooting in Firmware Version 1.3.0.
It looks like you're new here. If you want to get involved, click one of these buttons!