Personal View site logo
Make sure to join PV on Telegram or Facebook! Perfect to keep up with community on your smartphone.
Please, support PV!
It allows to keep PV going, with more focus towards AI, but keeping be one of the few truly independent places.
Consumer CPU sockets design embarassment
  • Vitaliy_KiselevVitaliy_Kiselev

    Standard Intel socket design

    image

    On the back it looks like

    image

    Issue with it is that cooler mount is just 4 bare holes in motherboard - totally unacceptable solution for anything besides stock cooler if you tray to use them as they are. As motherboard will bend.

    So any good cooler manufacturer ship you their own extra backplate and mounting hardware.

    image

    image

    Typical accessories set

    image

    This should not be the case. each motherboard must have proper backplate suitable for any cooler.

    sa7336.jpg
    800 x 706 - 169K
    sa7337.jpg
    623 x 493 - 80K
    sa7338.jpg
    629 x 739 - 68K
    sa7339.jpg
    559 x 490 - 56K
    sa7340.jpg
    526 x 367 - 25K
  • 2 Replies sorted by
  • Vitaliy_KiselevVitaliy_Kiselev

    @Psyco

    I'll get to Threadripper, their mount is better but also have design issues like holes being too close. As it was made for water cooling mount mostly. So most big air cooler manufacturers also supply their own hardware (not backplate but) and still install can be little weird.

    Consumer lineup is much more important, as design I referenced above already made big amount of damages and excessive expenses.

  • PsycoPsyco

    The Threadripper/TR4 Mainboards do have that steel backplate - it does make fastening a cooler/waterblock very easy.

Add a Comment